Optional Accessory - Makita XRT02 Manual De Instrucciones

Replacing wire guide B

Optional accessory

The wire guide B (in silver color) in the arm can be
replaced with an optional wire guide B (EG) (in black
color) according to the type of tying wire to use.
Find the right combination in the following table. Then
replace the standard equipped wire guide B with an
optional wire guide B (EG) if necessary.
Standard
equipped wire
guide B complete
(silver)
Annealing iron tie wire
Poly coated tie wire
Galvanized tie wire
— : The combination is not valid.
1. Loosen bolts A and B using the hex wrench
included in the tool package.
1
Fig.20
► 1. Hex wrench
1
Fig.21
► 1. Bolt A 2. Bolt B 3. Contact plate cover 4. Standard
equipped wire guide B (silver)
NOTICE:
Do not forcibly remove any bolts that
cannot be removed using the hex wrench.
Optional wire
guide B complete
(black)
-
-
4
2
3
2. Pull the contact plate cover up in the direction of the
arrow and remove it. Bolt B will be removed at the same time.
2
1
Fig.22
► 1. Contact plate cover 2. Bolt B
3.
Remove bolt A, and remove the standard
equipped wire guide B (silver).
1
2
Fig.23
► 1. Bolt A 2. Standard equipped wire guide B (silver)
4. Replace the standard equipped wire guide B (in silver
color) with an optional wire guide B (EG) (in black color).
1
Fig.24
► 1. Optional wire guide B (EG) (in black color).
12 ENGLISH