Disassembling And Cleaning - Makita XRT02 Manual De Instrucciones

2
3
Fig.48
► 1. Gear 2. Guide 3. Wire brush
4.
Push in the wire brush until its top end comes out
from the tip of the arm. And then pull out the wire brush.
This action is enough with one time.
Fig.49
► 1. Arm 2. Wire brush
5. Close the reel cover.
1
Fig.50
► 1. Reel cover
1
1
2
19 ENGLISH
Using the air duster gun
Open the reel cover, push the release lever, and lock it
with the lock lever. Then bring the air duster gun close
to the guide and blow the air. Make sure the air comes
from the tip of the arm.
1
Fig.51
► 1. Air duster gun 2. Guide
Cleaning with disassembly
If the cutter section is clogged or a wire is caught in it,
disassemble the parts and clean them.

Disassembling and cleaning

1. Loosen bolts A and B using the hex wrench
included in the tool package.
1
Fig.52
► 1. Hex wrench
2