Makita XRT02 Manual De Instrucciones página 20

1
Fig.53
► 1. Bolt A 2. Bolt B 3. Contact plate cover 4. Wire guide B
NOTICE:
Do not forcibly remove any bolts that
cannot be removed using the hex wrench.
2.
Pull the contact plate cover up in the direction of the
arrow and remove it. Bolt B will be removed at the same time.
2
1
Fig.54
► 1. Contact plate cover 2. Bolt B
3. Remove bolt A, and remove wire guide B.
1
2
Fig.55
► 1. Bolt A 2. Wire guide B
4
2
3
4. Turn wire guide B over and clean its inside.
Fig.56
5. Remove top plate, cutter B, link arm A and cutter A
from arm plate A. Then, clean them.
4
Fig.57
► 1. Top plate 2. Cutter B 3. Link arm A 4. Cutter A
5. Arm plate A
Assembling
When cleaning is finished, assemble the parts accord-
ing to the following procedure.
1. Install cutter A and link arm A to fit the shape of
arm plate A.
Fig.58
► 1. Cutter A 2. Link arm A 3. Arm plate A
20 ENGLISH
2
3
5
2
1
3
1