Publicidad
Idiomas disponibles
Idiomas disponibles
1. Insert one of the bolts on the left side slot of the
headband (5) from the inside. Adjust it according to the
desired position;
2. Fit the accessories to the bolt from the outside of the
headband;
3. Insert the bolt into the left-hand hole in the helmet;
4. Fit and tighten the accessories onto the bolt from the
outside of the helmet;
5. Insert the other bolt into the right-hand slot on the
headband. Place it in the same position as the bolt in the
left slot;
6. Attach the accessories to the bolt from the outside of the
headband;
7. Insert the bolt into the left hole in the helmet;
8. Fit and tighten the accessories onto the bolt from the
outside of the helmet.
1. Adjusting the depth:
▪ Release the locking pin and adjust the headband until
you reach the desired depth.
To the left the depth increases, to the right it decreases.
▪ Fit the locking pin to ensure the helmet does not move
during use.
2. Adjusting the diameter:
▪ Press the adjusting knob;
▪ Turn it clockwise to decrease the diameter and anti-
clockwise to increase it.
3. Adjusting eye distance and auto darkening filter:
▪ Loosen the locknuts;
▪ Move the helmet up or down to the desired distance;
▪ Tighten the nuts to fix the helmet position.
Ensure that both sides are placed in the same
position to ensure a proper vision.
4. Adjusting the angle of vision:
▪ Loosen the locknuts;
▪ Select the position (-3, -2, -1, 0, +1, +2, +3) of the
adjustment accessory according to the viewing angle
required;
▪ Tighten the nuts to fix the helmet position.
The auto-darkening welding helmet is designed to protect
the welder's eyes from radiation including visible light,
ultraviolet (UV) radiation and infrared radiation (IR)
resulting from certain gas welding processes.
This welding helmet is suitable for all types of electric
welding: covered electrodes, MIG/MAG, TIG, plasma
welding, cutting and laser welding.
Remove the protective films on both lenses before
using the helmet.
Never place the helmet or filter over hot surfaces.
Use the helmet within the temperature range of -10° C to
60° C.
Never immerse the filter in water.
Do not expose the filter to liquids and protect it from dirt.
Replace cover lens if cracked or scratched.
If the helmet does not darken with the appearance of the
arc, stop immediately and contact your official VITO
distributor.
This helmet can be used with two different operating
modes, welding or grinding.
Grinding mode: Used for performing metal grinding or
deburring tasks. In this mode, the filter darkening function
is disabled. The light intensity allows a clear view for
deburring or grinding with the helmet, providing facial
protection.
Welding mode: Used for most welding applications. In this
mode the darkening function is activated. When you spot a
welding arc, select a suitable shade level, delay time and
sensitivity.
1. Turn the operation mode selector button (9) to the
"GRINDING" position for grinding tasks or to the
"WELDING" position for welding tasks.
Publicidad
