Shark Hydrovac WD200 Serie Guia Del Usuario página 4

USING YOUR 3-IN-1 CLEANER
CHARGING ON THE DOCK
CORD WRAP
Charge the unit by placing it on the dock. Make sure the contacts on the body are aligned with the contacts
on the charging dock.
The Battery Icon on the main body will illuminate when charging begins.
When charging is complete and you need to use the unit again, lift it off the dock.
NOTE: When docked properly, the charging lights on the Main Body will blink, indicating that charging has begun. When
charging is complete, all three indicator lights will turn off.
NOTE: The main unit comes with a partial charge. For maximum runtime, charge fully before first use (approximately 4
hours). Leaving the unit charging will not damage battery life.
CONTACTS
DOCK CHARGING
USING YOUR 3-IN-1 CLEANER
FILLING THE CLEAN SOLUTION TANK
REMOVE THE CLEAN SOLUTION TANK
Press the release button and lift off the Clean Solution Tank.
FILL THE CLEAN SOLUTION TANK
Unscrew the cap and add water to the tank, up to the WATER line. Next, add Shark HydroVac™ Multi-Surface
Concentrate, filling to the HYDROVAC CONCENTRATE line. Replace the cap and reinsert the tank until it clicks
into place. The top of the tank should be flush with the top of the body.
NOTE: Only use Shark HydroVac Multi-Surface Concentrate, Shark HydroVac Disinfectant, and water with this product.
NOTE: Be sure to not overfill the Clean Solution Tank with more HydroVac Multi Surface Concentrate than instructed, as this
may clause streaking.
NOTE: Without sufficient water supply in the clean solution tank, HydroVac will not run.
1
2