Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USING YOUR 3-IN-1 CLEANER
POWER
Press and release the Power button on the handle
to turn on power. To turn off power, press the
button again.
CLEANING MODES
HARD FLOOR MODE
Use Hard Floor mode for powerful cleaning on bare
floors. To activate Hard Floor mode, turn on the unit
and tilt the handle back.
NOTE: To prevent leakage, DO NOT place the main body on the floor. The nozzle should always be kept flat on the floor.
NOTE: If you encounter a difficult stain, use Area Rug Mode for improved stain cleaning.
NOTE: If you encounter a stubborn odor on your floor or area rug, continue to clean in Area Rug mode until the odor is gone.
NOTE: If your floors are cloudy, streaky, or spotty after cleaning, it may be due to accumulated soap or grease residue. The
floor may require several cleanings with the Hydrovac.
CONTROLS
AREA RUG MODE
To clean area rugs, press the Area Rug icon on top of
the handle. The Area Rug light on the main body will
illuminate. To turn off Area Rug mode (and to switch
back to Hard Floor Mode), press the button again.
MAINTAINING YOUR 3-IN-1 CLEANER

SELF-CLEAN CYCLE

The self-clean cycle automatically cleans the system and the brushroll.
Recommended after every use
Place the unit on the charging dock.
1.
2.
Empty the Dirty Water Tank and make sure the
clean solution tank is at least half full.
3.
Press the Power Button to start the self-clean
cycle. The icon will pulse for the full 2-minute
duration of the cycle.
4.
DO NOT remove the unit from the dock during
the self-clean cycle. The icon will turn off when the
cycle is complete.
Empty the dirty water tank.
5.
See LED Glossary for more information on indicator
lights during self-clean cycle.
NOTE: Make sure the clean solution tank is at least half full and that the dirty water tank is empty before running the self-
clean cycle.

Publicidad

Tabla de contenido
loading

Tabla de contenido