Uline H-10162 Manual De Instrucciones página 3

ATTACHING BRACKETS TO MONITOR
Determine bolt size that is compatible with the monitor.
Using the square washers and spacers, install each
bracket to the monitor.
SQUARE WASHER
Small hole for M4 bolts (A1)
Medium hole for M5 and M6 bolts (A2, A3)
Large hole for M8 bolts (A4)
NOTE: For monitors with flat backs, spacers (A5)
are not needed. (See Figure 6)
Figure 6
Bracket
NOTE: For monitors with a curved back or
obstructions, place spacers (A5) on the side
closest to the monitor. (See Figure 7)
Figure 7
Bracket
PAGE 3 OF 14
INSTALLATION CONTINUED
Square
Washer
Spacer
Square
Washer
CONNECTING BRACKETS TO
MONITOR PLATE
1. Place plastic caps over the ends of the monitor
plate. (See Figure 8)
Figure 8
2. With second person, carefully lift and align brackets
on the back of monitor with the monitor plate. Tilt
top of monitor toward wall and place the top of
the brackets over the monitor plate. Slowly rotate
the bottom of the monitor toward wall and clip the
bottom of the brackets over monitor plate. This will
lock the brackets onto monitor plate.
NOTE: Strings that are used to release the
monitor from the mount may be visible after
installation. These can be hidden behind the
monitor using magnetic tips. (See Figure 9)
Figure 9
Plastic
Cap
Monitor
Plate
Magnetic Tip
1122 IH-10162