auna Splash Manual De Instrucciones página 36

EN
36
DAB+ OPERATION
Full scan
1. To activate auto scan, press the SCAN button and the display will show
"Scanning ..." and a progressing slide bar.
2. All the stations that have been found will be stored automatically. To
explore and listen to the found stations, press the  or  buttons to
select. Then press the ENTER button confirm into stations.
Manual Tuning
As well as the auto tune function, you can manually tune the receiver.
1. Press the MENU button to display the menu.
2. Press ⏮ or ⏭ buttons select 'select MANUAL TUNE' then press the ENTER
button to confirm.
3. Press the ⏮ or ⏭ buttons to cycle through the DAB+ channels, which are
numbered from 5A to 13F.
4. After your desired channel number is selected, press the ENTER button
to confirm. The display will show the multiplex. Press the MENU button
again to add selected channel to station list.
DRC (Dynamic compression)
1. Press the MENU button to display the menu.
2. Press the ⏮ or ⏭ buttons to select "DRC" and then press the ENTER
button to confirm DRC menu.
3. Press the ⏮ or ⏭ to select off / high / low.
4. Press the ENTER button to confirm.
Prune
You may remove all unavailable stations from the list
1. During DAB mode, press the MENU button to display the menu.
2. Press the ⏮ or ⏭ buttons to select "Prune" and then press the ENTER
button to confirm.
3. Press the ⏮ or ⏭ to select <Prune>, and then press the ENTER button to
delete the unavailable stations.
4. You can press the ⏮ or ⏭ to select <NO>, and then press the ENTER
button to cancel.
Software information
1. In DAB mode, press and hold the MENU button to display the menu.
2. Press the ⏮ or ⏭ buttons to select "SYSTEM" and then press the ENTER
button to confirm.
3. Press the ⏮ or ⏭ buttons to select "SW version".
4. Press the ENTER button to display the software version.