Publicidad
Side extension arms
• The arms are useful to support work pieces exceeding
the cutting table area.
• To install onto the worktable loosen the extension arms
locks (22).
• Set the extension arms on both sides of the table.
Tighten the locks.
22
Dust collecting pouch
• Set the dust-collecting pouch (33) in the dust-collecting
chute (12) found in the back of the cutter head column.
33
• To secure the work piece with the horizontal press, first,
lift the half nut (b).
• Then, pull the knob (c) outwards.
• Set the work piece onto the table and making contact
with the cutting guide (14).
• Push the knob until it touches the work piece.
• Lower the half nut and turn the knob to secure the work
piece.
8
ENGLISH
Presses
• To secure the work piece onto the cutting table use the
vertical and horizontal presses (18 and 19).
• Fix them in one of the orifices (20) regarding the job to
do. The horizontal press gets fixed in one of the two
orifices in the worktable. The vertical press gets fixed in one
of the orifices in the cutting guide (14).
12
• To secure in place the vertical press, tighten the lock
firmly (a).
c
Assembly
18
b
19
20
a
14
14
Publicidad
