Temperature Setting - EAS ELECTRIC EMZ185EX Manual De Instrucciones

4) ) Door open alert
The door does not emit a tone when it is opened but has an alert to warn when
the door is open for 2 minutes and will beep until it is closed. Press button B to
cancel the alert if necessary, but it is recommended to close the door as soon as
possible.
Display of normal running
In the event of a fault, the corresponding icons will flash according to the
following combinations:
Refrigerator:
Code Description
E1
Refrigerator temperature sensor failure
E5
Refrigerator defrosting sensor failure
E6
Communication error
E7
Ambient temperature sensor failure
Sticking problem with button
E10
Freezer:
Code Description
E1
Freezer temperature sensor failure
E5
Freezer defrosting sensor failure
E6
Communication error
E7
Ambient temperature sensor failure
E9
High temperature alarm in freezing chamber
E10 Sticking problem with button
If there is no fault, the display shows the setpoint temperature of the
refrigerator.
Conversion from freezer to refrigerator
Press the button
corresponding temperature icons shine.
Standby function
Longpress the

Temperature setting

The temperature setting will be changed once you press the SETTING button.
Then the refrigerator will run according to the new temperature setting after 15s.
Setting 1 Setting 2
InstantCool and InstantFreeze modes
To enter this mode, press the SETTING button until the icon
mode or the icon
mode will operate at 2°C for 150 minutes. InstantFreeze mode will operate at -24°
C for 24 hours. Both modes will automatically deactivate after this time or with
any manual mode or temperature change made by the user.
for 3 seconds to achieve Fridge/Freezer conversion, the
button for 10 seconds to set the standby function.
Setting 3
for InstantFreeze mode is illuminated. The InstantCool
17
Display
Icons and 2 shine at the same time
Icons and 3 shine at the same time
Icons 2 and 4 shine at the same time
Icons and 4 shine at the same time
Icons 2 and 3 shine at the same time
Display
Icons and -24 shine at the same time
Icons and -22 shine at the same time
Icons -20 and -24 shine at the same time
Icons and -20 shine at the same time
Icons -24 and -18 shine at the same time
Icons -24 and -22 shine at the same time
Setting 5
Setting 4
Setting 6
for InstantCool
V.1