HOMCOM 800-111 Instrucciones De Montaje página 24

flow out.
6. After water does not drop out any more, you can pour the water in each container out
then clean them thoroughly, now you can start brewing.
Note: There may be noise when pumping the water for the first time, it is normal, the
appliance is releasing the air inside. After about 20s, the noise will disappear.
PRE-HEATING
To make a cup of good hot Espresso coffee, we recommend you preheating the
appliance before making coffee, including the funnel, filter and cup, so that the coffee
flavour can not be influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with desired water, the water
level should not exceed the "MAX" mark in the tank. Then place the tank into the
appliance properly.
2. Select the steam mesh, Set steel mesh into metal funnel, make sure the tube on the
funnel aligns with groove in the appliance, then insert the funnel into the appliance from
the "Insert" position, and you can fix them into coffee maker firmly through turn it
anticlockwise until it is at the "Lock" position.
3. Place an espresso cup on removable shelf.
4. Then connect the appliance to power supply. Make sure the steam control knob is on the
OFF position.
5. Press the power switch " " one time, the power indicator turns on and the coffee indicator
blinks. After finish preheating, the coffee indicator lights solidly. Press the coffee switch ,
when there is water flowing out, close the pump immediately. The purpose of the step is to
pump the water of the tank into the housing.
6. When the lamp in coffee switch is illuminated, you should press the coffee switch again,
there will be hot water flowing out. When the lamp in it is extinguished, close the pump.
The pre-heating is finished.
MAKE ESPRESSO
1. Remove the funnel by turning it in clockwise. Add ground coffee steel mesh with
measuring spoon, a spoon ground coffee power can make about a cup of top-grade
coffee, then press the ground coffee powder tightly with the tamper
2. Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in
the appliance, then insert the funnel into the appliance from the "Insert" position, and you
can fix them into coffee maker firmly through turn it anticlockwise until it is at the "Lock"
position..
3. Pour the hot water in the cup, after the cup is warmed up, empty the water in the cup and
dry the cup, and then place the hot cup on removable shelf.
4. At the time, the lamp incoffee switch shall be illuminated, if it is extinguished, wait for a
moment, once the lamp in it is illuminated, you should press the coffee switch wait for a
moment, there will be coffee flowing out. Press the coffee switch again when the required
amount is got, and then the water pump stops working.
Do not leave the coffee maker unattended during making the coffee, as you need
WARNING: 1.