HOMCOM 800-111 Instrucciones De Montaje página 27

2.Fill the tank with water and descaler to the MAX level ( the scale of water and descaler is 4:1,
the detail refers to the instruction of descaler. Please use "household descaler", you can use
the citric acid (obtainable from chemist's or drug stores) instead of the descaler (the one
hundred parts of water and three parts of citric acid).
3.According to the program of pre-heating, put the metal funnel (no coffee powder in it) and jug
in place. Brewing water per " PRE-HEATING".
4. Press the switch one time, its red lamp will be illuminated, you should press the pump
Power
control switch, maker sure the coffee/steam selector , when there is water flowing out and close
the pump, and wait for a moment, the coffee maker begins to be heated.
5. When the lamp in pump control switch is illuminated, it shows the heating is finished.
Pressing the pump control switch and make two cups coffee (about 2Oz). Then close the pump
and wait for 5s.
6. Press the coffee/steam selector, the indicator in the pump control switch will be extinguished,
waiting for until the indicator in the coffee/steam selector is illuminated. Make steam for 2min by
turning the steam control knob, then turn the steam control knob to "o" position to stop making
steam. Press the Power switch for stop the unit immediately, make the descalers deposit in the
unit at least 15 minutes.
7. Restart the unit and repeat the steps of 4-6 at least 3 times.
8. Then press the coffee/steam selector , the lamp in pump control switch will be illuminated,
then press the pump control switch to brew until no descaler is left.
9. Then brew coffee (no coffee powder) with tap water in the MAX level, repeat the steps of 4-6
for 3 times (it is unnecessary to wait for 15 minutes in step of 6), then brew until no water is left
in the tank.
10. Repeat the step of 9 at least 3 times to make sure the piping is clean.
11. Follow the operation as below to cancel the descaling warning after finish descaling. Hold and press the
coffee switch and steam switch for 3 seconds at the same time under the standby mode, and then their
corresponding indicators quickly blink for 3 times, which means the descaling warning is canceled and the
working cycle is zeroed.