JULIUS MAYER JM35-F Manual De Instrucciones página 28

Mounting the motor
1. First lay the connecting cable in an empty pipe up to the junction box, observing the
local building and electrical regulations.
2. Lower the shutter completely and loosen the shaft connection.
3. Disassemble the roller shutter shaft.
NOTE! The roller capsule (counter bearing side) is usually secured with 2 opposite
screws.
4. Mount the motor bearing included in the scope of delivery on the side on which you
want to mount the motor. The motor can be installed on the left or right side.
5. Push the barrel ring adapter over the barrel ring on the motor head as far as it will go
1
. Make sure that the groove in the adapter is in the correct position.
6. Push the motor into the roller shutter shaft until it is completely inserted with the race
in the shaft 2 .
ATTENTION!
Never use a hammer when doing this! Adapters and drivers may not slide in very
smoothly, nevertheless do not hit the motor!
7. Now check whether the shaft can be mounted in the bearings without any problems
with the motor installed or whether you may have to shorten the shaft.
On the counter bearing side (opposite the motor side) is the roller capsule or telesco-
pic shaft. These can be pushed a few centimeters into the roller shutter shaft or pulled
out of the shaft.
8. Insert the motor inserted into the shaft into the motor bearing and the shaft with the
journal of the roller capsule into the counter bearing.
Secure the square spigot of the motor head with the locking pin included with the
3
bearing .
9. Fasten the roller capsule with two opposite screws
ATTENTION!
The roller capsule or telescopic shaft must be secured against displacement!
28
4
.
ASSEMBLY
1
2
3
4