Publicidad
Idiomas disponibles
Idiomas disponibles
Fanaway Fraser Installation Instructions
LIGHT KIT INSTALLATION
LIGHT KIT INSTALLATION (Fig. 6 & 7)
1. Loosen the screw (1) from the fan bracket. Align the two slot screws with the keyhole slots (2) of the light
kit bracket. (Fig. 6)
2. Turn the light kit counterclockwise until the slot screws are firmly at the end of the slots (2).
3. Secure screw (1) to the lamp shade bracket. Tighten all three screws. Do not over-tighten.
Fig. 6
4. Connect the quick connector to the lamp holder part (3). (Fig. 7)
5. Secure the lamp-holder part (3) to the light kit bracket by tightening the 3 screws. Do not over-tighten.
6. Install globes (4) (Not included) into the lamp holders. Do not exceed the maximum power rating.
7. Install the lamp shade cover on the Lamp base and shade assembly.
Fig. 7
7 | P a g e
Publicidad
