dB Technologies FIFTY Serie Manual De Uso página 42

5. UPDATING THE FIRMWARE
It is very important to keep the product firmware updated to ensure full functionality. Periodically check the
"DOWNLOADS" section of the http://www.dbtechnologies.com website.
1. Download and install the USB BURNER MANAGER onto your computer from the
CONTROLLER" section.
2. Download the .zip file of the latest firmware for your product from the "DOWNLOADS" section.
3. Connect the product to the PC using a USB cable (not supplied) with the correct connector type (see this
detail in the "AMPLIFIER AND CONTROL SECTION FEATURES" chapter)
4. Select "Open File" at the top right of the USB BURNER MANAGER screen.
5. Select the previously downloaded firmware file.
6. Follow the instructions shown on the screen.
7. Click "UPDATE".
You can also update the product firmware from the Firmware Update section of the AURORA NET software.
6. TROUBLESHOOTING
The speaker does not power up:
1. Check that the system is connected to a working power supply.
2. Check that the power cable with the POWERCON® TRUE1 connector is plugged in correctly.
3. If the problem persists, contact an authorised service centre.
The monitor turns on but does not produce any sound:
1. Check that the audio signal inputs are connected correctly, preferably using cables with Neutrik®
connectors.
2. Check that the cables used are not damaged.
3. Check that the mixer or audio source is on and clearly shows an output signal.
The sound from the monitor is distorted:
1. With the system powered on, first adjust the volume of the audio source. If the source LIMITER LED is on,
the signal may already be distorted before it reaches the speaker.
2. Check that the connection cables are not damaged. If they are, replace them (a damaged cable may cause
signal loss or alteration).
3. Check the preset EQ saved on the Service/User button that alters the frequency response of the output
signal.
Fifty Line
42
English
"SOFTWARE &
Cod. 420120397 REV. 1.0