VONROC VC509AC Traducción Del Manual Original página 15

3. Mount the applicable cleaning nozzle (8/9) on
the machine (refer to the previous paragraph
"Nozzle/brush").
4. Fill the detergent tank (16)
5. Set the on/off switch (1) to the
6. Press and hold the spray gun trigger (25) until
detergent starts to spray from the nozzle (8/9).
Note that it may take some time before the
detergent fills the tube (20) and reaches the
nozzle.
Cleaning:
1. Apply the nozzle (8/9) to the carpet or furniture
surface.
2. Press the trigger (25) to spray detergent while
moving the nozzle slowly and evenly across the
surface.
Dry vacuuming
Clean the HEPA filter (4) regularly to
maintain the suction power.
To avoid clogging of the HEPA filter (4) it is
recommended to use a dust collection bag
(7).
Very small particles, such as dust from
cement, soot and plaster are too fine to be
used with only the HEPA filter (4) and risk
getting into the motor and damaging it.
Therefore we strongly recommend using a
dust collection bag (7) when cleaning these
types of materials.
An overfilled, clogged dust collection bag
(7) can burst. Make sure to replace the dust
collection bag in a timely manner!
1. Install the HEPA filter (4) (refer to the previous
paragraph "Filters").
2. Place a dust bag (7) in the container (3).
3. Mount the applicable brush or nozzle (10/11)
on the machine (refer to the previous paragraph
"Nozzle/brush").
4. Set the on/off switch (1) to the "I" position.
Wet vacuuming
The vacuum cleaner is equipped with a
cut-off float (24). The suction power will be
cut off when the maximum filling level is
reached. When this happens, switch the
WWW.VONROC.COM
vacuum cleaner off immediately. Remove
the power plug from the mains outlet and
empty the container (3).
position. Clean the float (24) at regular intervals, and
inspect it for damage. A damaged float
must be replaced to ensure the safe
operation of the machine.
Never reach into the water to be suctioned
up. Danger of electric shock.
Immediately switch the machine off if foam
forms or liquids escape!
Do not use a dust collection bag (7) when
vacuuming liquids.
1. Remove the dust bag (7) from the container (3).
2. Install the foam filter (5) (refer to the previous
paragraph "Filters").
3. Mount the applicable brush or nozzle (10/11)
on the machine (refer to the previous paragraph
"Nozzle/brush").
4. Set the on/off switch (1) to the "I" position.
Airflow adjustment (Fig. G)
Use the slider (26) on the handle (13) to adjust the
suction.
Blower function (Fig. A, H)
Empty the container (3) and make sure it is
clear of debris before using the blower
function. The performance of the blower
function may be improved by removing the
filters (4/5/6).
Always wear safety goggles before using
the blower function.
Risk of flying objects. Keep bystanders
away while using the blower function.
1. Disconnect the flexible hose (14) from the
container (3).
2. Insert the end of the flexible hose (14) in the
blower port (27) on the other side of the machine
and turn clockwise to lock it in place.
EN
15