VONROC VC509AC Traducción Del Manual Original página 16

EN
3. Set the on/off switch (1) to the "I" position. Air
will blow out of the flexible hose.
Shut-off float
When the machine is used to clean up liquids the
container may become full at a certain point. The
shut-off float (24) in the air inlet will activate once
the container is at full capacity. Activation of the
float will cut off the suction power to prevent water
from entering into the air inlet. When this happens,
turn off the machine immediately and empty the
container before continuing to use the machine.
The shut-off float (24) may also be activated when
the machine is tilted or turned over. Turn off the
machine immediately and ensure it is in a fully
upright position before continuing to use it.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and dirt.
Remove very persistent dirt using a soft cloth mois-
tened with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
Container
Always empty and dry the container (3) after using
to the machine to vacuum liquids. The container is
not designed to store liquids for a prolonged period
and may corrode if it is not dried out after each use.
Built-in filter cleaning function (Fig. I)
When you notice a decrease in suction power, the
filters may be clogged. The machine is equipped
with a cleaning function to help unclog the filters.
1. Set the on/off switch (1) to the "I" position.
2. Push down on the filter cleaning button (28) a
few times to unclog the filter.
Temporarily blocking the vacuum cleaner suction
will make this cleaning function more effective at
unclogging the filter. The vacuum handle (13) may
be blocked by hand, while pressing the button (28)
16
with the other hand. For one-handed operation,
use the tip of the handle (13) to press down on
the button (28) – this will simultaneously enable
the cleaning function and block the airflow in the
handle.
Manually cleaning the filters
For optimal performance it is recommended
to regularly change or clean the filters
(4/5/6) depending on level of use.
1. Release the clamps (17) and remove the top
section (2) from the container (3).
2. Carefully remove the filters (4/5/6) from the
filter cage (22).
3. Use a mild soap and water solution to clean the
filters. Rinse the filters with clean water after-
wards.
4. Allow the filters to air-dry before re-installing
and using them again.
5. Re-install the filters (refer to previous para-
graph "Filters")
Shut-off float and filter cage
Regularly clean the shut-off float and the filter cage
using a soft cloth. While cleaning, inspect the parts
for damage. A damaged shut-off float or filter cage
must be replaced to ensure safe operation of the
machine.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
WWW.VONROC.COM