Publicidad
Idiomas disponibles
Idiomas disponibles
3.13
5
Nm
Nm
45
4
in-lbf
mm
3
Fig. 3.13
In an alternating (cross) pattern, using the supplied torque wrench and 4mm hex bit,
„
tighten each faceplate bolt approximately 1/2 turn, then repeat the cross pattern to torque
each bolt to 5 Nm / 45 in-lbf.
11
1
2
4
3.14
A
Fig. 3.14
Once assembly is complete, double-check to make sure the stem and handlebar are
„
aligned with the front wheel. Fig. 3.14 A shows a properly aligned handlebar/stem. Fig. 3.14
B shows an improperly aligned handlebar/stem.
B
Publicidad
