stayer MINICOM B Manual De Instrucciones página 16

3.2 Assembling
Valve Adapter (FIG. 2)
•Push adapter 6 downwards onto the threaded section of
the valve rod or one of the three accessories delivered
together with the inflating device (fig. A2).
•When the adapter is positioned completely down on the
threads, press lever 6 with your finger downward so as to
fix it in its position (figure A3).
•To release the adapter 3, pull lever 6 upwards and pull
the adapter 3.
•Operate your inflating device only with the nozzles as
included or with standard valves for tires (figure A4).
Accessories
• Place the universal valve adaptor 3 over the stud of the
inflator needle or the conical nozzle.
• Press lever 6 of the universal valve adaptor downward
until it wedges into its position.
• Put inflator needle 10 or the conical nozzle into the object
that is to be inflated.
Remark:
The conical nozzles 9 and standard extension nozzles 11
and the inflator needle 10 shown in figure C are delivered
together with the compressor.
3.3 Illustrated description
1. Universal adapter sleeve air valve
2. Cord
3. Universal adapter for valves.
4. Gauge
5. Motor housing
6. Lever universal adapter
7. Switch on / off
8. 12V Plug
9. Standard nozzle
10. Needle for inflating
11. Nozzle extension
4. Operating instructions
4.1 Positioning and testing
To switch the compressor on, you must use the ON/OFF
switch 7 located at the upper portion of the compressor.
Connection to power supply:
Risk of unsafe operation
• Do not operate the compressor when the motor of the
automobile is running.
• Always completely extend the 12V DC cable 2 before
each use.
• To turn the compressor on, plug the 12V adapter into the
vehicle's 12V socket for accessories, and press switch 7
ENGLISH
16
towards red in position "I".
To turn the compressor off, press switch 7 into position
"O".
4.2 Setting operations:
Risk of explosion. Too much air pressure
causes risk of blasting. Check which is the
maximum
manufacturer of the articles that will be inflated.
• To operate the valve adapter 3, position the lever 6
upward and then penetrate the valve to inflate the object
adapter or floating (9-11) or balls (9) and close the lever 6
to seal the circuit (Figure A1-A4)
• To activate the compressor, connect the adapter to 12
volt accessory outlet 12 volt vehicle and press the red
switch to position "I".
• If necessary, turn the key to start the car capable of
powering a contact.
• To turn off the compressor, press the 7 "O".
REMARK: Let the lever 6 always in its upward position
when not in used.
Pressure gauge
This gauge located on the upper portion of the inflating
device, will provide you with a lecture in PSI in black
(kilogram per square centimeter) and as well in bares in
red: kg/cm2 Newton per square meter). In the case of
vehicle tires, it is recommended to control the pressure
lecture with another gauge for tires.
5. Maintenance and servicing instruction
5.1 Cleaning and servicing
To clean the tool, only use a damp cloth. Never allow
water penetrating into the tool, and do not immerse
any of its parts into a liquid, making sure that you have
disconnected the plug from the electrical power point.
5.2 Repair service
The customer service will provide you with advice on your
eventual inquiries regarding repair and maintenance of
your product as well as on spare parts.
You may also obtain Exploded view drawings and
information on the spare parts on the internet under:
info@grupostayer.com
Our team of technical advisors will be happy to advise you
in respect of the acquisition, application and settings of
the products and accessories.
16
pressure established by the