Publicidad
Idiomas disponibles
Idiomas disponibles
1. Power button
2. Temperature (timer) increasing button
3. Temperature (timer) decreasing button
4. Remote control signal receiver window
5. Mode button
6. Wind speed button
7. Timer on/off button
8. Water full indicator light
INSTALLATION (The pictures below are for the guideline to install the appliance. The appearance of the
appliance may be different from the product you purchased.)
The unit shall be installed on a flat surface where the air outlet would not be blocked. The required
distance around the unit should be at least 30cm. (Fig.1)
The unit shall not be installed in a laundry room.
Twist both hose connectors onto the hot air exhaust hose. (Fig.2)
Insert the hose connector (Air conditioner end) into the brackets on the back of the unit. (Fig.3)
Put the other end of the exhaust hose to the nearby windowsill. (Fig.4)
Fig.1
OPERATION
Always let the appliance rest for at least 2 hours after moving it from one location to another.
Before use, check up whether the exhaust hose has been mounted properly. Plug in the appliance.
1. Power button
Press the button "POWER" to turn on the appliance. The appliance will begin to work under cooling mode
at low wind speed. Press the button again, the appliance will be turned off.
Fig.3
- 7 -
9. High speed indicator light
10. Low speed indicator light
11. Timer indicator light
12. Digital display
13. Cooling mode indicator light
14. Dehumidification mode indicator light
15. Fan mode indicator light
Fig.2
Fig.4
Publicidad
