Publicidad
Idiomas disponibles
Idiomas disponibles
9
Lay the drawer sides (J&K) down on a flat hard surface. Carefully line up the drawer bracket (11) with the
holes in the drawer sides (J&K) as shown. Using a hammer, tap each drawer bracket stem part way into
each hole. Repeat this process until the drawer bracket is fully seated on the drawer side.
marcado "LEFT"
11
x8
marked "LEFT"
J
finished edge
borde acabado
bracket orientation
orientación del soporte
x4
11
11
bracket orientation
orientación del soporte
14 /20
marked "RIGHT"
marcado "RIGHT"
K
finished edge
borde acabado
B345986333W0 0
Publicidad
