Publicidad
Idiomas disponibles
Idiomas disponibles
SC 20 • Operating Manual
• Steer the machine forward into the coverings. The oscillating blade should slice under the
material and remove it from the floor.
• The machine must be pushed through the material to remove it effectively.
Placing your foot on the pedal will provide additional leverage but make sure never to force
the machine!
Never let the rear wheels leave the floor because it is dangerous for the user and the ma-
chine may be damaged (Fig. 8)!
• If you are having difficulties removing the material, use the corner of the blade (А).
• Press the red button on the switch on upper handle to stop the machine (B).
• Return the angle adjuster to neutral position and remove the blade when finished your
work (C).
Fig� 8
CARE AND MAINTENANCE
Maintenance plan
The machine has been specially designed to reduce the time needed for maintenance work to a
minimum. However, some maintenance work is essential.
This will enable the machine to operate in a trouble-free manner and give you good service for
many years.
Always interrupt the energy supply before performing maintenance work!
• Remove the mains plug!
• Allow the motor to cool down fully.
Daily or after every 10 hours of operation:
• Clean the outside of the machine.
• Check the condition of the blade.
Do not use solvents.
Weekly or after every 50 hours of operation:
• Check the bearings (Arrange for after-sales service to change damaged bearings.)
• Check screwed connections (Tighten any loose screwed connections, arrange for after-sales
service to change any damaged assemblies.)
12
B
C
Care and maintenance
A
Publicidad
