Aqua Marina CALIBER Manual Del Usuario página 6

4. Install the air deck floor before inflation.
5. Start pumping air into the side chambers and the floor of the kayak in
sequence. Keep inflating until the required air pressure is reached.
DO NOT OVERFILL!
Step 1: Pump the side chambers up to 1.45psi / 0.1bar.
Step 2: Pump the air deck floor up to 8.0psi / 0.55bar.
PARTIALLY INFLATE THE SIDE CHAMBERS AND THE KAYAK FLOOR AND CHECK
THAT THE FLOOR IS TUCKED UNDERNEATH THE SIDES.
WARNING: Do not leave your kayak under direct sunlight as this may cause
over-inflation!
6.
Firmly cap each valve after inflation.
NOTE：After multiple times of inflation – deflation, there may be slight
displacement of the valve. Replace it to the correct position when deflated.
Then inflate to required air pressure to use.
TIP: If the pump piston starts to squeak, apply some spray silicone on the
piston shaft.
Step 2
6
Step 1
Step 1