Publicidad
Idiomas disponibles
Idiomas disponibles
5. Installation
5. Installation
Personnel: Skilled personnel
EN
5.1 Installing the drivers
A user account with administrator rights is required to install the device
drivers.
If you do not have these rights, log in with an appropriate account or ask your
system administrator.
If a device with the same USB chipset is already installed on your PC, the adapter will
automatically be installed when it is plugged in.
If this is not the case, you will be prompted to install the driver.
1. Insert the data medium with the driver into the drive.
2. Plug the adapter into the USB port of the PC.
⇒
The "Hardware wizard" for the installation of the "CP2102 USB to UART Bridge
Controller" appears.
3. Click on the button [Continue].
4. Confirm the selection window for the driver search with the [Next] button.
5. Select "Specify a destination" in the search selection.
6. Then enter the driver path on the data medium in "Search":
⇒
Select either via the CD drive or via the file path in which the driver was saved.
7. Switch to the CD drive and go to the "Driver" directory.
8. Now select the directory that corresponds to your Windows version (e.g. for Vista
Business 64 bit the folder "Windows Vista x64").
9. Then click on the following directory V X.X.X and confirm the path with [Next].
⇒
(V X.X.X describes the driver version e.g. "V 5.4.29")
10. Confirm the driver suggestion with [Next].
⇒
The installation is now being completed. This must then be confirmed again with
[Finish].
The computer must be restarted to complete the installation.
The adapter is now installed on your system and is available to all users.
Another COM port is now available for use with the software (e.g. WIKA-Cal or GSoft).
12
WIKA operating instructions, model USB6300
Publicidad
