Publicidad
STEP 2A Attach Wall Plate
CAUTION:
Avoid potential personal injury or property damage!
● Drywall covering the wall must not exceed 5/8 in. (1.5 cm)
● Minimum wood stud size:
nominal 2 x 4 in. (5.1 x 10.2 cm) actual 1 ½ x 3 ½ in. (3.8 x 8.9 cm)
● Stud center must be verified
1
LOCATE STUD
4
POSITION TEMPLATE
05
2X
To calculate your precise wall plate location,
check out our HeightFinder at sanus.com
TIP:
[www.sanus.com/1172].
7
SECURELY TIGHTEN
07
08
CAUTION:
Avoid potential personal injury or property damage!
Both lag bolts
MUST BE firmly tightened to prevent unwanted
07
movement of arm assembly
fastened to the wall before continuing on to the next step.
6
Visit
HeightFinder™
sanus.com
/1172
06
2X
. Ensure the wall plate is securely
06
Wood Stud Installation
Max. 5/8 in. (1.5 cm)
2
VERIFY
5
DRILL
2 ¾ in. (7.0 cm)
2X
Be sure you drill into the
CAUTION:
CENTER of the stud.
TIP: You can make small
level adjustments by loosening
the bottom lag bolt
shifting the wall plate until level.
Min. 1 ½ in. (3.8 cm)
3
6
REMOVE COVERS
1/8 in.
(3 mm)
06
8
07
06
and
07
Min. 3 ½ in. (8.9 cm)
MARK
P
P
INSERT COVERS
P
P
Go to STEP 3 on PAGE 8.
Publicidad
