Pride Mobility i-Go S20 Manual Del Propietário página 11

I I I . B AT T E R I E S A N D C H A R G I N G
WARNING! If the battery charger is equipped with cooling slots, then do not attempt to
insert objects through these slots.
WARNING! Be aware that the battery charger case may become hot during charging. Avoid
skin contact and do not place on surfaces that may be affected by heat.
WARNING! Do not attempt to operate your scooter with depleted batteries, as you may
become stranded.
WARNING! Battery chargers are not suitable to be used by children.
WARNING! If your battery charger has not been tested and approved for outdoor use,
then do not expose it to adverse or extreme weather conditions. If the battery charger
is exposed to adverse or extreme weather conditions, then it must be allowed to adjust
to the difference in environmental conditions before use indoors. Refer to the manual
supplied with the battery charger for more information.
Follow the easy steps in fi gure 7 to charge your batteries safely:
Figure 7. Battery Charging Procedures Diagram
To safely charge your Lithium-Ion battery:
1. Place your scooter next to an electrical outlet. See fi gure 8.
2. Remove the key.
3. Ensure that the scooter is in drive mode. See fi gure 5.
4. Connect the supplied 3-pin XLR Lithium-Ion charger into the 3-pin charging port on the scooter.
5. Plug the charger power cord into the wall electrical outlet. See fi gure 8.
6. Wait two (2) minutes. Two (2) red LED lights on the charger signify that charging has begun.
7. The batteries are fully charged when the LED on the battery charger is green.
NOTE: If the steps above were not performed in the correct order, unplug the charger cord from both the wall
electrical outlet and the scooter, wait one (1) minute, and then repeat the steps above in the order shown.
8. Unplug the battery charger from the scooter and electrical outlet.
i-Go™
11