Pride Mobility i-Go S20 Manual Del Propietário página 20

V. D I S A S S E M B LY / A S S E M B LY A N D
DISASSEMBLY
To disassemble your scooter (see fi gure 15):
1. Fold your scooter as shown in step 6 in fi gure 14. Refer to
V. "Disassembly/Assembly and Folding/Unfolding" for more
information.
2. Disengage the front-to-rear latch to free the front and rear
sections as shown in step 6.
3. Turn both pivot pins 90° so they are horizontal to ground as
shown in step 7.
4. Lift the front section of the scooter up and away from the rear
as shown in step 8.
Removing the seat back from disassembled scooter (see fi gure 16):
1. Loosen both threaded knobs located on the seatback weldment.
2. Remove the seatback by lifting up on it.
ASSEMBLY
To assemble your scooter:
1. Line up the indicators on the front and rear sections and place
the front section's hooks onto the rear section's pins as shown
in step 8.
2. Turn both of the main pivot pins 90° toward the ground as
shown in step 7.
3. Engage the front-to-rear latch to secure the front and rear
sections together as shown in step 6.
4. Unfold your scooter as shown in fi gure 14. Refer to
V. "Disassembly/Assembly and Folding/Unfolding" for more
information.
TRANSPORT
To transport your folded scooter (see fi gure 17):
1. Fold your scooter as shown in step 6 in fi gure 14. Refer to
V. "Disassembly/Assembly and Folding/Unfolding" for more
information.
NOTE: Ensure the front-to-rear latch is engaged, securing the
front and rear sections of the scooter.
2. Raise the tiller using the tiller lever.
3. While holding onto the handlebar, pull the tiller forward off of the
kickstand and rubber bumpers.
4. Freely roll the unit on the rear tires
20
F O L D I N G / U N F O L D I N G
IDENTIFICATION KEY
1. Front Section
2. Rear Section
3. Battery
Figure 15. Dissasembly
Figure 16. Seat Back Removal
Figure 17. Transport
i-Go™