Romstal FEKA 600 M-NA Instrucciones página 11

SAFETY
Use is allowed only if the electric system is in possession of safety precautions in
accordance with the regulations in force in the country where the product is
installed (for Italy CEI 64/2).
The power supply cable must never be used to carry or shift the pump.
Never pull on the cable to detach the plug from the socket.
For appliance with type Y attachment: if the power cable is damaged, it must be
replaced by the manufacturer or by their authorized technical assistance service,
so as to avoid any risk. In the case of pumps for a swimming pool: the pump MUST
NOT be used if there are people in the water. For appliance with type X
attachment: If supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
Failure to observe the warnings may create situations of risk for persons or
property and will void the product guarantee.
RESPONSIBILITY
The Manufacturer does not vouch for correct operation of the electropumps or
answer for any damage that they may cause if they have been tampered with,
modified and/or run outside the recommended work range or in contrast with other
indications given in this manual.
INSTALLATION
If the system is used for the domestic water supply, respect the local regulations
of the authorities responsible for the management of water resources.
Choosing the installation site verified that:
- The voltage and frequency on the pump's technical data plate correspond to the
values of the power supply system.
- The electrical connection is made in a dry place, far from any possible flooding.
ENGLISH EN
5