Descargar Imprimir esta página

Allen + Roth LWSWMSJ Manual De Instrucciones página 2

Ocultar thumbs Ver también para LWSWMSJ:

Publicidad

Idiomas disponibles

Idiomas disponibles

HARDWARE CONTENTS (shown not actual size)
AA
BB
Touch-up Pen
M4 x 60mm Screw
Qty. 1
Qty. 4
FF
EE
Wood Dowel
Drywall Anchor
Qty. 3
Qty. 2
SAFETY INFORMATION
Please read and understand this entire manual before attemting to assemble or install the product.
1. Please read the Assembly Instructions prior to assembling the unit.
2. To avoid damage, assemble the unit on a sturdy, level and non-abrasive surface.
3. Keep all hardware and parts out of the reach of children.
4. Please wait until all steps are completed before fully tightening bolts.
5. Make sure all bolts and screws are tightly fastened before the unit is used.
6. Check that all bolts, screws are tight at least every 3 months or as needed.
WARNING
THIS UNIT IS INTENDED FOR USE ONLY WITH THE MAXIMUM WEIGHTS INDICATED. USE
WITH PRODUCTS HEAVIER THAN THE MAXIMUM WEIGHTS INDICATED MAY RESULT IN
INSTABILITY CAUSING POSSIBLE INJURY. DISTRIBUTE WEIGHT EVENLY.
SHELF MAXIMUM:
9.07kg / 20 lb
HOOK MAXIMUM:
1.1kg / 2.5 lb
EVENLY DISTRIBUTED.
ENTIRE UNIT MAXIMUM
WEIGHT CAPACITY:
22.7 kg / 50 lb
EVENLY DISTRIBUTED
CC
DD
M4 x 25mm Screw
M3.5 x 12mm Screw
Qty. 12
Qty. 12
3
PREPARATION
Please read the instruction sheets completely before assembly. Examine all packaging material before
discarding carton. Remove any remaining staples from the carton before discarding. Remove all parts
from carton and separate into groups as indicated on part list. Please ensure all parts are included
prior to assembly. Use of power tools must be with caution and ensuring setting at low-torque, avoid
damaging the wood panels.
Estimated Assembly Time: 30 minutes.
Tools Required for Assembly: Phillips Screwdriver, Level, Power Drill, 3/16 in. Drill Bit, 3/8 in. Drill Bit,
1/2 in. Socket Wrench, Stud Finder, Marking Pencil, Tape Measure, Step Ladder, and Hammer.
ASSEMBLY INSTRUCTIONS
1. Attach the Back panel (C) to the Lower left frame (E) and
lower right frame (F), using the M3.5x12mm screw (DD).
Hardware Used
DD
3.5x 12mm Screw
2. Attach the upper shelf panel (A) and shelf panel (B) to
the upper metal frame (D), using the M4 x 25mm screw
(CC).
Hardware Used
CC
M4 x 25mm Screw
1
x4
C
E
2
CC
A
x 8
B
D
4
DD
F
D

Publicidad

loading

Este manual también es adecuado para:

3592134