Descargar Imprimir esta página

Lavor GV Vesuvio Manual De Instrucciones página 25

Ocultar thumbs Ver también para GV Vesuvio:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Filling the tanks with water and detergent
Fill the tanks with water and detergent in the following way:
- Stop the machine by turning the main switch to OFF
- Fill the tanks
WARNINGS
- Never use distilled water! The machine may not run correctly.
Water supply from the water main
unit and to the water supply.
á.
Boiler steam blow-off
Follow the instructions below:
- A few minutes before the end of the work shift, turn off the boiler by pressing the BOILER START luminous
green push-button. Keep on using the steam gun until the pressure gauge indicates a value of 0-1 BAR;
- Carefully open the boiler drain cock, situated on the machine right side and drain all the water from
the boiler into a suitable container;
- Once the water has been drained up completely, close the cock;
Drain
cock
Description of the start sequence
After carrying out all the connections and the preventive inspections described in the previous chapters, start the machine according to the
following instructions:
1) Before starting the generator, fill the tanks up to the level with water and detergent.
2) Turn the main switch situated on the control panel to ON.
3) Press the BOILER START push-button on the control panel board.
4) Press the GUN START push-button on the control panel board.
5) If the water level in the boiler is already correct, the thermoregulator will indicate the temperature value previously set by the operator after
approx. 7-10 minutes. At this point, the steam gun can be used.
6) If the display show H2O and it flashes and an acoustic alarm is heard, it means that there is no water in the tank. Fill the tank (see "Filling the tanks
with water and detergent").
Detergent
tank
Machine use
Water
tank
7
Pressure gauge
25

Publicidad

loading

Productos relacionados para Lavor GV Vesuvio