Publicidad
Idiomas disponibles
Idiomas disponibles
17
Screw
18
Washer/ nut
19
3.3. Working with the device
If the engine is placed on the ground:
1. Remove the mounting plate.
2. Attach the mounting plate adapters to the back of the engine. Select the correct
size of screws so that the engine is securely fastened.
3. Turn the stand upside down and align the socket in the column with the mounting
plate. Slide the plate into the socket and secure it with the locking pin.
3. Slowly turn the stand with the engine to a vertical position.
If the engine is raised at stand level:
1. It is not necessary to remove the mounting plate. Align the height of the engine
with the height of the stand. Attach the engine to the mounting adapters using screws
of the correct size. Lock with the locking pin.
A fixed engine can be turned by removing the locking pin and rotating the handle. To
lock the engine in position, put the locking pin back in.
3.4. Cleaning and maintenance
a)
After each cleaning, all components should be well dried before the device s
used again.
b)
Store the device in a dry and cool place protected from moisture and direct
sunlight.
c)
Regularly inspect the device for technical failure and damage.
d)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or metal
scraper) as these may damage the surface of the device.
Regularly maintain the device by lubricating its moving parts at points
e)
of friction, especially if the device is stored outdoors.
Publicidad
