Publicidad
disposal company. Keep children away from the device. There is a risk of serious
injury and electric shock. This device is intended for use by adults only.
Warnings, precautions, and instructions contained herein may not contain every
possible hazardous situation. Please use common sense when operating the
device.
Initial Setup
Before the operation, you should remove the packaging from the HEPA filter. To
do this, please turn the purifier upside down and remove its cover by turning it
counterclockwise (See Figure b). Then, remove the HEPA filter from the device
body using the fabric strips (See Figure c), remove the filter packaging, and insert
the filter back into the device body. Tighten the cover by turning it clockwise (See
Figure d). After that, you should connect the air purifier to the source of power
(mains socket) using the power adapter included in the package of supply. The
power connector of the adapter must be inserted into the power port in the device
casing, while the plug of the adapter – into the mains socket.
ATTENTION! Never use a non-original power adapter to connect to and power on
the device, as this may damage the purifier.
Button Panel Control
The purifier will be switched to the Standby Mode upon connection to the mains
socket using the power adapter. The control panel of the device contains the
following 6 LED buttons (See Figure e):
•
POWER button used to switch the purifier from the Standby Mode to the
Operation Mode, as well as to turn off the purifier, or turn on the anion filter.
• SLEEP
,
speed of the purifier in the following way: Sleep – quiet mode, Speed Mid –
medium rotation speed of the fan, Speed High – high rotation speed of the fan;
aeno.com/documents
SPEED MID and
SPEED HIGH buttons used to switch the fan
9
Publicidad
