Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions of Button Operation:
Power button: Press this button, the indicator light shows blue and the machine starts to work in
normal mode with default humidity setting of 50%RH and low fan speed. The fan starts working and
the compressor will begin to work 3 seconds later.
Press this button again, the compressor stops and the fan will close60 seconds later. All the indicators light sare
off and it enters the standby mode.
Timer button: Press this button to set timing from 0 to 24 hours in one-hour increments/decrements,
along with the Add button and Minus button. When the machine is running, press this button to set
the shutdown time; when it is in the standby mode, press this button to set the startup time. If users want to cancel
time setting, press the button until it shows 00 on the display.
Add and
The humidity adjustment is only effective in the normal mode. The initial humidity is 50%. Press these two buttons
to programme room humidity from 20% to 80% in 5% increments or 5% decrease. When the set humidity value
reaches at one end, press again and it will reset to the other end. If the indoor humidity is lower than the set
humidity, the machine stops automatically.
Fan speed button: Press this button to choose low fan speed(sleep) or high fan speed(turbo).
Mode button: Press this button to choose normal or drying clothes mode.
SETTINGS
Operation mode setting
Normal Operation
Press POWER key to turn on the unit.
The unit operates in normal mode with the default 50% humidity set-point.
The fan runs at Turbo speed by default.
Press POWER key again to turn off the dehumidifier.
The fan keeps running for a while and then stops.
The display reads room relative humidity.
Minus button: (Timing and humidity setting):
53
Publicidad
