Mafell LO65 Ec Traducción Del Manual De Instrucciones Original página 24

5.4.1 Plunge milling
While milling ensure that the workpiece is secured, that
the router with base plate 3 and / or the limit stops
rests as even as possible and with an as large as
possible surface against the workpiece and that large
depths are milled in stages. Once you have set the
milling cutter speed, firmly hold onto the machine with
both hands and switch on the machine. Plunge into the
material up to the limit stop with an even feed and then
lock the machine. Only mill in counter direction.
5.4.2 Milling with parallel stop (see Fig. 1)
Parallel stop 13 is used to accurately guide the
machine along a straight workpiece edge.
Conversion:
•
Push the guide rods 36 laterally into the prism-
shaped openings of the base plate.
•
Roughly set the parallel stop to the desired
distance to the milling cutter and tighten the wing
screws 68a.
•
Knurling screw 34 permits you to accurately set
the distance to the milling cutter. Then tighten the
wing screws 68b.
Adjust the sliding pads on the parallel stop
The sliding pads 15 can be pushed together to adjust
the stop surface during processing of edge ends. To
do so, unscrew cylinder-head screws 83a, 86 and set
the sliding pads close to the milling cutter or push them
together completely.
5.4.3 Milling according to template
With the template guide 507 (see Fig. 4) it is possible
to mill shapes using self-made templates. Screw the
template guide onto the underside of base plate 3
using the countersunk screws 77. The template must
be wide enough to allow a secure guiding of the
machine.
5.4.4 Milling with parallel stop and roller edge
guide (see Fig. 5)
(also available as special accessories)
The roller edge guide B can be fastened on parallel
stop 13 at the end of the screws using hexagon nuts
C. With this guide it is possible to carry out milling work
parallel to edges of any shape.
6 Service and maintenance
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.
6.1 Storage
Clean the machine thoroughly if the machine is not
used for a longer period of time. Spray blank metal
parts with a rust-proofing agent.
-24-
Danger
Pull the power plug during all
service work.