jcm-tech BASIC-PLUS Manual De Instrucciones página 5

Input switch
Option No.
1 (SEC.OP.)
2 (SEC.CL.)
3 (S.EDGE OP.)
4 (S.EDGE CL.)
5 (FC.OP.)
6 (FC.CL.)
7 (STOP)
Light indicators
Function
POWER
SAFETY
TIMER PROG.
RADIO PROG.
START
PED.
FC.CL.
FC.OP.
SEC.CL.
SEC.OP.
POWER
Buttons
TEST
TIMER PROG.
RADIO PROG.
Timers
Controlling
Motor power
Lower position - OFF
Security Open contact connected
Security Close contact connected Security Close contact not connected
Security Open edge connected
Security Close edge connected
End of run open connected
End of run close connected
Stop button connected
Indicates
Power
Safety edge error or security contact error
Time programming mode
Radio programming mode
Open/close function
Pedestrian open function
End of run Close
End of run Open
Security Close contact
Security Open contact
Security Close contact
Start
Start operation programming
Start transmitter programming
Minimum
25%
jcmtechnologies
Upper position – ON (default option)
Security Open contact not connected
Security Open edge not connected
Security Close edge not connected
End of run open not connected
End of run close not connected
Stop button not connected
5
Default status
Normally on
Normally off
Normally off
Normally flashing
Normally off
Normally off
Normally on
Normally on
Normally on
Normally on
Normally on
Maximum
100%