Satel abax2 INT-KWRL2 Manual De Instrucciones página 3

SATEL
Full manual is available on
website and download the manual.
The device should be installed by qualified personnel.
Before installation, please read the full manual thoroughly.
Changes, modifications or repairs not authorized by the manufacturer shall void your rights
under the warranty.
Disconnect power before making any electrical connections.
There is a danger of battery explosion when using a different battery than recommended by the
manufacturer, or handling the battery improperly. Do not crush the battery, cut it or expose it to
high temperatures (throw it into the fire, put it in the oven, etc.).
Do not expose the battery to very low pressure due to the risk of battery explosion or leakage of
flammable liquid or gas.
Be particularly careful during installation and replacement of the battery. The manufacturer is
not liable for the consequences of incorrect installation of the battery.
The used batteries must not be discarded, but should be disposed of in accordance with the
existing rules for environment protection.
The keypad is designed for indoor installation. The place of installation should be readily accessible to the
system users. When selecting the installation location, take into account the communication range of the
ABAX 2 / ABAX system.
1. Open the keypad enclosure.
2. Install the batteries and add the keypad to the wireless system (see full manual).
3. Put the cover on the catches and snap the enclosure shut.
4. Place the keypad in the location intended for its installation.
If you want to hold the keypad in your hand, grab the device from its left side (on its right side, there is
the antenna, which must not be covered).
5. Check the level of signal received from the keypad by the ABAX 2 / ABAX controller. If the signal level is
lower than 40%, select another place for installation. Sometimes, it is sufficient to shift the device ten or
twenty centimeters.
The ARF-200 tester makes it possible to check the radio signal strength at the place of future
installation without having to put the keypad there.
6. Open the keypad enclosure.
7. Place the enclosure base against the wall and mark location of the mounting holes.
8. Drill the holes in the wall for wall plugs (anchors).
9. If the APS-055 power supply is to be used as the external power source, run the power wires through the
opening in the enclosure base. Use flexible wires with a cross-section of 0.5-0.75 m
10. Using wall plugs (anchors) and screws, secure the enclosure base to the wall. Select wall plugs specifically
intended for the mounting surface (different for concrete or brick wall, different for plaster wall, etc.). When
installed, the device must withstand a pull-off force of at least 50 N.
11. If the APS-055 power supply is to be used, connect the power wires to the "+" and "–" terminals (see Fig. 1).
Use a 1.8 mm flathead screwdriver.
12. Put the cover on the catches and snap the enclosure shut.
13. Lock the cover using screw(s).
Hereby, SATEL sp. z o.o. declares that the radio equipment type INT-KWRL2 / PRF-LCD-A2 /
VERSA-KWRL2 is in compliance with Directive 2014/53/EU. The full text of the EU declaration
of conformity is available at the following internet address: www.satel.pl/ce
INT-KWRL2 ● VERSA-KWRL2 ● PRF-LCD-AX2
Quick installation guide
www.satel.pl
. Scan the QR code to go to our
2
.
3