VONROC CD505DC Traducción Del Manual Original página 6

EN
minimum thickness of 1.5 mm
tension cable reel, always fully unroll the cable.
2. MACHINE INFORMATION
Intended use
The machine is intended for driving in and loose-
ning screws as well as for drilling in wood, metal,
ceramic and plastic and for impact drilling in brick,
brickwork and masonry.
TECHNICAL SPECIFICATIONS
This manual has been drawn up for
different sets / article numbers. Check the
corresponding article number in below
specifi cations table for the correct
composition and contents of your set.
Batteries
Model No
included
CD505DC
-
S_CD505DC
CD801AA
S2_CD505DC
2 x CD801AA
S3_CD505DC
CD803AA
Machine information
Voltage
Chuck capacity
Torque settings
No load speed
Position 1:
Position 2:
No load impact rate
Position 1:
Position 2:
Weight
Sound pressure level L
Sound power level L
WA
Hand-arm vibration a
h
(Impact drilling in concrete)
Hand-arm vibration a
h,D
(Drilling into metal)
6
. If you use a ex-
2
Chargers
included
-
CD802AA
CD802AA
CD802AA
20V
13 mm
21+ Drill mode + Impact
drill mode
0-400 /min
0-1500 /min
0-6400 /min
0-24000 /min
1.2 kg
89.9 dB(A), K=3dB(A)
PA
99.9 dB(A), K=3dB(A)
14.265 m/s K=1.5 m/s
2
1.746 m/s K=1.5 m/s
2
Model No
Battery Type
Voltage
Capacity
Recommended charger
Weight
Model No
Charger input
Charger output
Charging time 2Ah battery
Charging time 4Ah battery
Recommended batteries
Weight
Model No
Battery Type
Voltage
Capacity
Recommended charger
Weight
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other batte -
ries could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 62841; it may
be used to compare one tool with another and as
2
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
2
CD801AA
Lithium-Ion
20V
2.0 Ah
CD802AA
0.3 kg
CD802AA
220-240V,50Hz 0.4A
21V 2.5A
60 minutes
120 minutes
CD801AA, CD803AA
0.36 kg
CD803AA
Lithium-Ion
20V
4.0 Ah
CD802AA
0.65 kg
WWW.VONROC.COM