stayer L20 Manual De Instrucciones página 24

outer ring of the protection casing (3). Leave it installed
and screwed in if you are using the cutting disc, uninstall it
by removing the screws if you are using a nylon spool, as
the outer edge could interfere with the correct operation
of the spool.
Installation of the BRUSH CUTTER 36V L20
double handle
Remove the adjustment knob (15) by unscrewing it
completely
Remove the support bracket and install the double handle
between both parts
Screw in the adjusting knob (15) again. Before tightening it
completely, place the handle in the most suitable position
for the work to be carried out
Installing the harness RUSH CUTTER 36V L20
- Adjust the harness hanger in a comfortable position.
- Buckle the harness at the hanger.
BRUSH CUTTER 36V L20 cutting disc
CAUTION: NEVER use unit if blade is warped or has
teeth that are chipped or missing. Replace a damaged
blade immediately.
CAUTION: Always wear heavy-duty work gloves when
handling and installing a blade.
Fit the disc with the nut and washer in the order indicated
in the image.
Rotate the disc assembly with the washer and nut until the
holes line up, allowing the rod to fully seat into the holes.
Use the hex wrench to tighten the locknut by turning
counterclockwise while holding the head fixed with the
rod.
ENGLISH
24
Nylon spool BRUSH CUTTER 36V L20
Attach the spool and washer in the order indicated in the
image.
Rotate the spool assembly with the washer until the holes
line up, allowing the rod to fully seat into the holes.
Tighten the spool by turning counterclockwise while
holding the head fixed with the rod.
24