KNF N952KTE-W Manual De Instrucciones página 84

Installation and connection
Connected com-
ponents
Pump discharge
24
à
no tensile and pressure forces are exerted on the con-
nection point of the cables (strain relief)
Connecting the pump
1. Compare the data of the supply voltage with the informa-
tion on the type plate. See the pump type plate for the
maximum current draw of the pump.
2. Plug the power cable connector into a properly installed
socket with a connected PE contact.
Replace the detachable power cables with power cables
that are adequately dimensioned. Use a C14 power ca-
ble for device plugs conforming to IEC/EN 60320-1,UL
498, CSA C22.2 no. 42, with protection class 1.
6.3 Pneumatic connection
CAUTION
à
Only connect components to the pump that are designed
for the pneumatic data and thermal requirements of the
pump. (see Chapter 3 Technical data [} 14]).
à
If the pump is being used as a vacuum pump, safely (re-
lating to the medium and noise) discharge the possibly hot
pump discharge via the pneumatic outlet of the pump.
Translation of Original Operating and Installation Instruction, KNF
Diaphragm pump N952KTE-W N952KT.29E-W
Personal injury or property damage
through ejected plugs
If not removed, the plugs on the pres-
sure side of the pump can be ejected
during operation by the resulting over-
pressure.
à
Remove the plugs during installa-
tion.
à
Wear appropriate personal protec-
tive equipment.
339866-336533 02/23