Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
3. Select desired mounting height and fix the lower
vertical supports to the upper vertical supports with
16 - 4.2 x 8 mm screws.
4. Install another horizontal support just above the top
part of the lower vertical supports with 24 - 4.2 x 8
mm screws.
5. Fix the hood motor (only for two fan model) or the
hood assembly (only for one fan model) to the lower
vertical supports with 32 - 4.2 x 8 mm (two fan model)
or 16 - 4.2 x 8 mm (one fan model)screws according
with the hood Installation Instructions.
6. Place each part of the inner support on the structure
with 2 - 4.2 x 8 screws. Make sure the inner supports
are the closest possible to 45º regarding vertical
supports.
7. Assemble the internal supports of the structure as
indicated in the figure. Fasten them with 2 - 4.2 x
8 screws in the central part. You can elongate this
supports, depending on your structure height.
36" Hood
Min. height
51 ¹/₄"
(130.2 cm)
42" and 54" Hoods
Min. height
50 ¹/₄"
(127.6 cm)
NOTE
Locate 2 or 3 inner support on each inner side of the
structure according with the selected mounting height.
For a maximum of every 15
support must be installed on each side of the hood.
Max. height
79 ¹/₄"
(201.3 cm)
Max. height
79 ¹/₄"
(201.3 cm)
" (40 cm) of height, an inner
/₄
3
ENGLISH 3
Publicidad
