Fulgor Milano F7PBW24S1-R Manual De Usuario página 5

1. IMPORTANT DIRECTIONS FOR SAFETY AND THE ENVIRONMENT
EN
Symbols used in the Guide:
Note
Recommendations for correct use of the
appliance
Important
Directions for avoiding appliance damage
Warning
Indications for avoiding injury to people
1.3 Caring for the environment
> Pay special attention to correct disposal procedure
for all the packaging materials.
>
The appliance must not be disposed of with urban
waste. Contact local waste disposal centres for on
how to dispose of recyclable waste.
> Prior to disposal, cut the power supply cord and
make it impossible to close the door.
> During disposal, avoid damage to the refrigeration
circuit.
> The appliance does not contain hazardous
substances for the atmospheric ozone layer, neither
in the refrigeration circuit nor in the insulation.
8
1.4 Cleaning, sanitization and mainte-
nance
> Any work on the appliance must be carried out
by a qualified technician or the After-sales Service.
Warning
To avoid contamination of food, please
respect the following instructions:
> Opening the door for long periods can cause
a significant increase of the temperature
in the compartments of the appliance.
> Clean regularly surfaces that can come in
contact with food and accessible drainage
systems.
> If the refrigerating appliance is left empty
for long periods, switch off, defrost, clean,
dry, and leave the door open to prevent
mould developing within the appliance.
2. INSTALLATION
2.1 Installation
Make sure that installation is performed correctly,
adhering to all of the instructions in the specific
installation guide provided with the appliance.
The appliance must be connected to ground in
compliance with electrical system safety standards.
> Position the appliance with the aid of a second
person.
> Never use the open door to lever the appliance
into place when fitting.
> Avoid exerting too much pressure on the door
when open.
> The appliance must not be installed near heat
sources. If this is not possible, suitable insulation
must be used.
>The appliance must not be exposed to direct
sunlight.
>
Do not use the appliance outdoors.
> Installation and servicing should be carried out
by qualified personnel in accordance with current
standards.
> Have the electrical supply installed by authorised
technical personnel.
> For avoiding dangers, if the power supply cable is
damaged, contact technical support immediately
and they will replace it, so as to prevent any risk.
> Always use any necessary/ required personal
protective equipment (PPE) before performing any
work on the appliance (installation, maintenance,
positioning or movement).
> Before performing any operation on the appliance,
switch off the power supply.
>Do not try to repair the appliance yourself or
without the assistance of a qualified technician.
>CAUTION: while positioning the appliance, make
sure that the power supply cable is not caught or
damaged.
>To prevent instability of the appliance, install and
secure it correctly as indicated in the instructions
provided in this manual.
2.2 Connection to the electrical power
supply
The appliance operates at 115 V AC, 60 Hz and is
equipped with a power supply cord with a 3-prong
grounded plug, which must be connected to a
dedicated 3-prong (15 Amp) grounding-type wall
receptacle.
Important
Do not use extension cords and/or
adapters for connection.
Warning
If energy is supplied through an alternative
energy power source (solar, geothermal,
etc..) or if home automation systems are
installed, it may cause malfunctions with
this appliance's electronics in which case
connecting it to an isolation transformer
is recommended.
2.3 Refrigerant
The refrigerant isobutane (R600a) is contained
within the refrigerant circuit of the appliance, a
natural gas with a high level of environmental
compatibility, which is nevertheless flammable.
> During transportation and installation of the
appliance, be certain that none of the components
of the refrigerant circuit become damaged.
> If the refrigerant circuit should become damaged:
– avoid open flames and sources of ignition;
– thoroughly ventilate the room in which the
appliance is situated.
Caution:
risk of fire / flammable materials.
EN
9