Simy My-MOB Guia Del Usuario página 23

How to activate your beacon?
Caution: never activate the beacon if you are not in distress.
My-MOB can be activated manually or automatically. When the beacon is activated manually, it is done so
independently from the life jacket. The beacon user must activate it in the event of an emergency.
Manual activation
There are two stages to manual activation:
Initial state of the beacon
When the beacon is not being used, the arming clip must face the front so as to block the antenna cap and
thus avoid any risk of accidentally activating it.
Arming the beacon
To arm the beacon, push the arming clip towards the back, to free the cap.
Activating the beacon
To activate/trigger the beacon, slide the antenna cap downwards. The cap is then ejected and the
antenna is deployed. The beacon is activated and the emergency signal is sent out.
Important: Three seconds after activation, a continuous and piercing initial signal (buzzer) will sound for
two seconds. The white signalling LED will then flash slowly for twelve seconds, without transmitting any
radio alert yet. You can therefore switch the beacon o during this time if it was activated involuntarily or
by accident. After those twelve seconds, the beacon will send out a radio wave emergency signal.
22
Position the clip
facing the front
Position the clip
facing the back
E