Setup And Troubleshooting - LD Systems LDMEI100G2 Manual De Usuario

SETUP AND TROUBLESHOOTING

SETUP
For optimal transmission, position the transmitter at a minimum height of 1 m and orient the antenna vertically upwards. When using multiple
wireless systems in one installation, make certain that the antennas do not touch or cross. Do not position the transmitter in the immediate vicinity
of metal objects and digitally controlled devices (CD players, computers, digital consoles, etc. ): There should be a direct line of sight between
transmitter and receiver.
TROUBLESHOOTING
PROBLEM
No sound or volume too
low.
Distortion or noise.
Distorted sound.
DISPLAY
Receiver: Display is switched off.
Transmitter: Display is switched off.
Receiver: is on, but the RF indicator is
not lit.
Receiver: is on and the RF indicator is lit.
Receiver: RF indicator is on.
Receiver: Battery symbol is flashing.
Transmitter: Level indicator is too high
SOLUTION
Make certain that the batteries are not dead and
the receiver is on.
Check the connection between power supply and
transmitter. Turn on the transmitter.
Make certain that the transmitter and receiver are
set to the same radio frequency.
Reduce the distance between transmitter and
receiver and make certain that there is a direct
line of sight between transmitter and receiver.
Make certain that the transmitter antenna is
installed correctly.
Increase the volume at the receiver and check the
headphone connection.
Check the input level on the transmitter and
increase it if necessary.
Increase the distance to possible causes of
interference (digitally controlled devices, e.g., CD
players, computers, digital consoles...).
Use a different radio frequency.
Replace the batteries with new ones.
Reduce the volume at the level controls of the
transmitter or the volume of the source device.
11