Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SYSTEM SETUP
TRANSMITTER PROGRAMMING
1
Select a GROUP and/or CHANNEL:
Press the SET button (GROUP flashes). The desired frequency group is selected using the arrow keys
the SET button again (CHANNEL flashes). The desired frequency group is selected using the arrow keys
Confirm the input with SET.
Note: Any number of receivers can be used with one transmitter, provided all receivers are supposed to receive the same signal and are
set to the same radio frequency as the transmitter.
3
Audio input level display:
The audio input level is indicated by two bar indicators (channel left/right, see Fig.
Note: Any number of receivers can be used with one transmitter, provided all receivers are supposed to receive the same signal and are set
to the same radio frequency as the transmitter.
4
LC display options:
Audio input level, transmitter radio frequency (see Figure
Adjust the audio input level using the level controls on the rear panel of the transmitter. Higher input levels result in improved signal to noise
ratio. The input stage must not be overloaded.
RECEIVER PROGRAMMING
5
Select a GROUP and/or CHANNEL:
Press the SET button (GROUP flashes). The desired frequency group is selected using the arrow keys
button again (CHANNEL flashes). The desired frequency group is selected using the arrow keys
2
3
).
4
).
6
and
(see Figure
and
(see Figure
5
and
(see Figure
). Press the SET
6
and
(see Figure
). Confirm with SET.
1
). Press
2
).
9
Publicidad
Tabla de contenido
Solución de problemas
