Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Supplementary documentation
Make sure the supplied instruction
manuals of the charger and operating
arm are available. Please read and
understand them before using the
device.
Power pack charging
Only charge the power pack using the
charger approved by the manufacturer.
The designations of the approved chargers
are listed in the enclosed CE Declaration of
Conformity.
Attention!
The power pack is supplied partially charged.
Before using the device for the first time, fully
charge the power pack to ensure effective
performance.
The power pack is permanently installed in
the operating arm.
Power pack charging must be carried out ac-
Î
cording to the instructions in the supplementary
documentation.
Assembly
Risk of injuries.
ÂWhen using the tool, incorrectly fitted
parts can lead to severe injuries up to
and including death.
ÂThis tool can only be operated, if all parts
are fully fitted and tightened and there
are no damaged parts!
¾ Therefore first read the entire chapter,
before fitting the parts.
¾ Fit the parts carefully and completely.
¾ Use tools as specified.
28
Start-up
WARNING!
CAUTION!
WARNING!
Risk of injuries.
¾ Parts may only be fitted and removed
when the motor is switched off and the
operating arm, in which the permanently
installed power pack is located, is
removed.
Sharp cutting chain. Tool still running!
¾ Before any work on the device, first
remove the operating arm with the
permanently installed power pack.
¾ Wear safety gloves before any work on
the chain.
Risk of injuries.
ÂAn incorrectly fitted cutting chain will
result in erratic cutting behaviour of the
tool.
¾ Fit the chain so that it rotates in the
indicated direction of rotation.
Attaching the chain A B C D
Loosen the locking screw A 1 and remove the
Î
cover A 2 .
Position the bar with the longitudinal hole on the
Î
threaded bar A 3 .
Note
Ensure that the chain tensioning plate points
forwards C [1].
Note
Check for correct seating of the guide screw
on the rear side of the bar in the guiding
groove B [1].
Push the bar as chose as possible to the sprocket.
Î
Place the chain around the bar and drive
Î
sprocket A 4 .
Note
Ensure the chain moves in the correct
direction B [2].
Check the position of the bar and chain on the tool
Î
C .
Position the cover D 1 and tighten it with the
Î
locking screw D 2 .
WARNING!
CAUTION!
WARNING!
Start-up
Publicidad
