SNOWJOE 24V-X2-13SS Manual Del Operador página 12

2. Remove the belt from the drive wheel (Fig. 13).
Fig. 13
3. Remove the screws, the washers from the drive wheel
(Fig. 14).
Fig. 14
4. Disassemble the right side cover by removing the four (4)
screws that hold it in place (Fig. 15).
Fig. 15
Right side cover
5. Use one hand to secure the auger; at the same time, use
the other hand to remove the auger assembly nut on the
right side. (Fig. 16).
Fig. 16
Belt
Auger
assembly nut
6. From the left side, remove the auger axle set (Fig. 17).
Fig. 17
Washer
Screw
7. Remove the old auger from the housing (Fig. 18).
Fig. 18
8. Install the replacement auger by following the above steps
in reverse order. (Fig. 19).
Fig. 19
12
Auger axle set
Auger