Descargar Imprimir esta página

SNOWJOE 24V-X2-13SS Manual Del Operador página 13

Pala quitanieve inalámbrica 48 v máx. | 4.0 ah | 33 cm

Publicidad

Idiomas disponibles

Idiomas disponibles

Replacing the Belt
m
WARNING!
Make sure to turn off the unit and remove
batteries before performing any maintenance task on your
cordless snow shovel.
1. Disassemble the left side cover by removing the four (4)
screws that hold it in place (Fig. 12).
2. To remove the old belt from the drive wheel, use one hand
to slowly turn the auger while using the other hand to lift
the belt (Fig. 20).
Fig. 20
3. Replace a new belt in place. Place the left side cover back
into position and refasten the four (4) screws.
Replacing the Scraper Bar
m
WARNING!
Make sure to turn off the unit and remove
batteries before performing any maintenance task on your
cordless snow shovel.
1. Turn the snow shovel over. Using a drill, remove the five (5)
screws that secure the scraper bar to the base of the unit
(Fig. 21).
Fig. 21
Remove
the screws
2. Remove the old scraper bar (Fig. 22).
Fig. 22
3. Install a new scraper bar and fasten it securely to the
Drive wheel
housing with the five (5) screws (Fig. 23).
Belt
Fig. 23
Auger
Fix with screws
Lubricating the Cordless Snow Shovel
This cordless snow shovel does not need lubrication. All
bearings are lubricated at the factory for the life of the product.
Storage
1. Examine the cordless snow shovel thoroughly for worn,
loose or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
Sun Joe
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
2. Remove the batteries from the cordless snow shovel
before storing.
3. Store the cordless snow shovel indoors in a locked, dry
place out of the reach of children to prevent unauthorized
use or damage.
Battery + Charger Off-Season Storage
1. Do not expose your battery pack or charger to water,
rain or allow them to get wet. This could permanently
damage the charger and the battery pack. Do not use oil
or solvents to clean or lubricate your battery pack, as the
plastic casing can become brittle and crack, causing a
serious risk of injury.
2. Store the battery pack and charger at room temperature
away from moisture. Do not store in damp locations where
corrosion of terminals may occur. As with other battery
13
Scraper bar
dealer or call the Snow Joe
®
+
®
+ Sun Joe
®
®

Publicidad

loading