Publicidad
Idiomas disponibles
Idiomas disponibles
Charging the Battery
1. Press the push lock button on the battery to pull the
battery pack out of the equipment (Fig. 1).
Fig. 1
Push lock button
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, insert the
charger's plug into the electrical wall outlet. When you
plug in the charger, two green lights will illuminate and
stay green (Fig. 2).
Fig. 2
Power on
Green
3. Place the battery packs into the charger by sliding
the packs to lock them into position. When you insert
batteries into the charger, the two green lights will go off,
and the red lights will illuminate to indicate that batteries
are charging (Fig. 3).
Fig. 3
Charging
Red
Fully
Charged
Green
4. When the charger lights turn green, the batteries are fully
charged (Fig. 3).
NOTE: A fully discharged pack with an internal
temperature in the normal range will fully charge in 1 hr 50
mins (between 32°F/0°Cand 113°F/45°C).
5. If the light indicators do not come on at all, check that
the battery packs are fully seated into the bay. Remove
the battery packs and reinsert. If the problem persists,
contact an authorized Snow Joe
call the Snow Joe
1-866-SNOWJOE (1-866-766-9563) for assistance.
6. When charging is complete, remove the batteries from the
charger (Fig. 4).
Fig. 4
Charger
7. Timely recharging of the batteries will help prolong the
batteries' life. You must recharge the battery packs when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery packs to become fully
discharged, as this will cause irreversible damage to the
batteries.
Battery packs
9
+ Sun Joe
®
®
+ Sun Joe
customer service center at
®
®
dealer or
Publicidad
