Publicidad
Idiomas disponibles
Idiomas disponibles
Lubrication
• Pneumatic tools need constant lubrication along their
useful life and during the operation. The compressed air
needed in the tool to run carry humidity which could
oxidize the motor and bearing in the tool. To prevent this
possibility, it is necessary to constantly deliver lubricating
oil through a
centralized filter-oiler system installed between the air
compressor and the tool.
• Any excess of oil in the motor is
WARNING
immediately expelled through the exceeding oil escape.
Keep the escape free of obstructions and never point it
towards people or objects.
• If not using the tool for long periods of time, it shall need
to be lubricated with care.
• After 60 hours' operation, the tool mechanism need a
little greasing. Excessive grease may diminish power.
10
ENGLISH
Brand UNI-LL-1/4
Maintenance
Service
• Servicing the tool shall be carried out every 3 months
only in a
Service and maintenance carried out by not certified
people mat y be dangerous and can cause severe
personal injuries as well as making the product Warranty
void.
• Malfunction in the tool caused by no using the
recommended dose of lubrication, or not complying
with this Instructions, or repairs carried out by people
not certified by
with the Warranty. We reserve the right to carry out
technical improvements without notice.
Notes
Authorized Service Center.
will not be covered
Publicidad
