ENGLISH
DESCRIPTION OF THE CLIPPER
AND ITS ACCESSORIES
1. Cutting guide
2. Precision cutting guide for
extremely short cutting lengths:
0.5, 1, 1.5, 2 and 2.5 mm.
3. Blades:
Moving cutter:
- Three-dimensional etching
process for exceptional
sharpness.
Fixed cutter:
- Titanium coating: unbeaten
durability
4. Turbo
5. On/off switch
6. Lead for corded operation
and charge
7. Scissors
8. Comb
9. Lubricating oil
10. Cleaning brush
CHARGING
Ensure that the clipper is switched
off. Insert the small plug firmly
into the clipper, then the mains
plug into the wall socket. The
charging indicator lamp will light
up to indicate that charging has
begun. After 16 hours, the clipper
will be fully charged. A full charge
will supply enough power for
about 1H.
Charge the clipper for 16 hours
before the first use.
To keep the batteries in good
condition, avoid charging the
clipper too frequently.
CORDED OPERATION
Insert the small plug into the
clipper, then the mains plug into
the wall socket. Wait for about a
minute then switch on.
TURBO FEATURE
For an extra burst of power,
push the "Turbo" button on the
top side of the clipper. This will
boost the motor of your clipper,
producing faster cutting action
and increased cutting power for
the more difficult cutting tasks.
USE OF THE CUTTING GUIDES
IMPORTANT : Always place the
cutting guide on the clipper
BEFORE switching the clipper
on. Always switch the clipper off
to change the cutting guide.
The cutting guides provide you
an even cutting length.
The clipper comes with 5 cutting
guides offering 17 cutting lengths:
N°1
3-6-9 mm
N°2
12-15-18 mm
N°3
21-24-27 mm
N°4
30-35-40 mm
N°5
"Precision" cutting guide:
0.5-1-1.5-2-2.5 mm
To install a cutting guide, insert
the two lugs at the bottom of the
cutting guide in the notches at
the bottom of the blades. Push
and hold the two buttons on
each side of the clipper head to
clip the guide on the blades.
5